304 Stainless Steel Mechanical Properties & Application Selection

Dec 31, 2025

Leave a message

Q1: What are the typical mechanical properties of 304 stainless steel at room temperature?

A1: Typical room-temperature mechanical properties (annealed state): 1. Tensile strength: ≥515 MPa. 2. Yield strength: ≥205 MPa. 3. Elongation: ≥40%. 4. Hardness (Brinell): ≤201 HB; (Rockwell B): ≤92 HRB. These properties ensure that 304 stainless steel has good load-bearing capacity and deformation ability, suitable for various processing and application scenarios.

Q2: How does cold working affect the mechanical properties of 304 stainless steel?

A2: Cold working (such as stamping, bending, rolling) will significantly change the mechanical properties of 304 stainless steel: 1. Tensile strength and hardness increase significantly (work hardening). 2. Elongation and ductility decrease. For example, after cold rolling with a reduction rate of 20%, the tensile strength can reach 700 MPa or more, but the elongation will decrease to about 20%. Cold working can be used to improve the strength of 304 stainless steel products, but it should be noted that excessive cold working may cause brittleness.

Q3: How does temperature affect the mechanical properties of 304 stainless steel?

A3: Temperature has a significant impact: 1. Low temperature (-270°C to 0°C): Tensile strength slightly increases, and toughness remains good without brittle fracture, making it suitable for low-temperature environments (such as cryogenic equipment). 2. High temperature (200°C to 870°C): Tensile strength decreases with increasing temperature, but oxidation resistance remains good. When the temperature exceeds 870°C, the strength decreases sharply, and corrosion resistance is also affected, so long-term use at high temperatures above 870°C is not recommended.

Q4: How to select 304 stainless steel based on mechanical property requirements?

A4: Selection criteria: 1. For stress-bearing structural parts (such as supports, beams), select annealed 304 stainless steel with sufficient tensile and yield strength. 2. For parts requiring cold forming (such as stamping parts, bending parts), select annealed 304 with high elongation (≥40%). 3. For parts used in low-temperature environments (such as cryogenic storage tanks), confirm that the toughness of 304 stainless steel meets the requirements at the corresponding low temperature. 4. For parts requiring high strength, use cold-worked 304 stainless steel or consider 304H grade.

Q5: What is the fatigue strength of 304 stainless steel, and what scenarios need to consider it?

A5: The fatigue strength of 304 stainless steel (at 10^7 cycles) is about 170-200 MPa. Fatigue strength refers to the maximum stress that the material can withstand without fatigue failure under repeated cyclic loads. Scenarios that need to consider fatigue strength include: 1. Mechanical components subject to repeated motion (such as shafts, gears). 2. Pipeline systems subject to alternating pressure (such as water pumps, compressors). 3. Architectural components subject to wind load and vibration. In these scenarios, it is necessary to ensure that the actual stress does not exceed the fatigue strength of 304 stainless steel.

Comparison Of SUS321 And SUS304: Titanium-Stabilized Vs General-Purpose Austenitic Stainless SteelHow long will 409 stainless exhaust last?Comparison of SUS321 and SUS321H: Titanium-Stabilized vs High-Carbon Titanium-Stabilized Austenitic Stainless Steel

Send Inquiry